Project details
Project type
Dedicated circuits, subpanel, and smart control for gutter heat tape
Primary service
Panel Upgrades
Notable conditions
Large home, long gutter runs, roofing and gutter work by another contractor, requested phone-based control
Customer type
Fished wiring, added a basement subpanel for heat tape circuits, installed GFCI-protected outdoor heat tape circuits, and set up coordinated smart control
Confirmed scope
Fished wiring, added a basement subpanel for heat tape circuits, installed GFCI-protected outdoor heat tape circuits, and set up coordinated smart control
An Allentown homeowner was having roofing and gutter work completed and wanted gutter heat tape powered as part of the project. The home was large enough that the heat tape plan required more than a simple exterior outlet.
Energized Electric fished wiring through the home, added a subpanel in the basement for the heat tape circuits, and created a control setup so the homeowner could turn the system on together from a smart control. Because the equipment is outdoors, GFCI protection was part of the circuit planning.
The practical takeaway is that specialty exterior loads can require dedicated circuits, panel space, protection, switching, and thoughtful routing inside a finished home.
What similar customers should know
Exterior heat tape and similar specialty loads should be planned around circuit capacity, GFCI protection where required, control method, routing, weather exposure, and manufacturer requirements. Do not assume an existing outdoor receptacle is enough for a large or complex setup.
